Head Shaving – How To Get The Best Results

Hair shaving has become quite well-known! It is for many an image statement. In the case of male pattern baldness some men prefer to shave their head completely instead of sporting the traditional horseshoe-shaped head hair.

Whatever the motivation behind the decision to shave or shaved head that is close to the hairline this information can ease the transition and reduce the discomfort best clippers for bald head.

Head Shaving Tips:

If you are shaving your hair with an electric hair trimmer, you should use olive oil instead of machine oil to lubricate. If the oil comes into contact with your skin olive oil is more beneficial for scalp, particularly when there are cuts when shaving the head.

Disposable razors aren’t suitable for shaving your head. They break down too fast.

For the best head shaving results, Invest in a good hand razor from a trusted company like Wilkinson Sword or Gillette and ensure that you always shaving with the sharpest blade.

If you’re starting with a complete length of hair cut the hair first with an electric razor prior to using a hand-shaver. Begin by trimming the side or back, and then clip it near to your scalp.

To minimize the chance of razor burn and cuts while shaving the head, it is crucial for hair and scalp to be completely wet to ensure that hair follicles and the skin are smooth before shaving.

Hair shaving in the shower after the shower could make it simpler. After that, the hair and scalp are submerged for a long time. A lesser amount of shaving cream is needed. Apply shaving cream on small areas at a given time so that it doesn’t melt too fast.

To do head shaving in the shower, wash the locks and the scalp warm water over the faucet or drape a warm, wet towel around your head for a few minutes. Apply an extremely dense layer of shaving gel that is about one-half inch thick, on your entire head. Let it sit for five minutes prior to beginning to shave.

When shaving your head, be sure to avoid repeated strokes in the same region to limit the chance of nicks and razor burn.

If the growth of hair is in an stubble level, lengthy strokes of several inches might be feasible.

When the hair’s thicker or was cut with clippers that are electric, use tiny strokes of approximately half an inch.

Start shaving the head in the areas at the area where the hair is the most dense which means that the blade is at the most difficult regions. End the process in lighter areas.

Before you begin shaving your head start by wetting the blade with hot water and create the cut about one inch wide wherever you choose to begin. The next strokes are created from this point at the most optimal position to cut near to your scalp and also at the hair’s root.

Some prefer using mirrors initially to get used to shaving their heads. After some time some find it to be more difficult with a mirror as opposed to without. Shaving by touching comes with the experience.

After shaving the head, you can run your fingers across the scalp to ensure that any missing areas can be easily identified. After that, carefully run your fingers over the area once more. Be sure to not repeat this process more than twice or three times to avoid burning from the razor.

Rinse the head , then dry it off.

To speed up the healing process following shaving your head to remove nicks and cuts Apply vitamin E oil on the scalp.

Aloe Vera pure gel can be very beneficial for soothing skin that is suffering due to shaving your head. It also provides an attractive shine to the hair.

Make sure you allow enough time to shaving the head. The rush can cause a lot of cuts and nicks particularly when shaving this area of your body.

Prepare yourself for the sensation of a completely new and unfamiliar sensation while shaving your head. The scalp will be extremely sensitive, and a blast of cool air, like the breeze outside is quite an experience!